WEEK 11

TITLE OF PROJECT : Soldering the component on PCB.

OBJECTIVES : Soldering is the process of soldering components to circuit attached to the PCB.

METHODS :
- The equipment required is solder, solder paste, soldering iron & stand.
- Eye soldering iron should be cleaned before use.
- Enter the component on the right.
- Heat up the soldering iron and solder to the component.
- Cut away excess components using cutter.

RESULT :
- All materials can be prepared and caused the job step can be made smoothly.

ANALYSIS :
- After the steps before this work is completed, the next process was done by performing a soldering components. Replacement parts must be correct before soldering to unforeseen happens.

CONCLUSION :
- Making soldering should be careful because it can cause burns on yourself and also can damage components if negligent.
- It should be efficient to do so soldering is not a problem.